Location:Home-> ->Detail

Preventive maintenance

|March 29 , 2019

Preventive maintenance


1.Handle with care. Most of repair of the tool can be traced back to careless operations. Although pneumatic tools have a certain strength, they should not be used as hammers or levers, nor should they be intentionally dropped on the floor or dragged on the floor.


2.Lubrication of gear tools. Some types of pneumatic tools contain gears and should be lubricated regularly with gear grease. Most of these tools have external hydraulic couplings that can be serviced by ARO's grease gun 7464-1. Grease 33153 (5 lb. tank) for gears and bearings; lubricate and install grease 36460 for "0" ring.


3.Excessive lubricant in the tool can affect speed and power. Each set of gears should contain approximately 1 in 8 ounces of grease.


4.Rinse the tool with three parts of detergent and one part of light oil solution for every 40 hours of operation. After rinsing, apply a small amount of spindle oil to the air inlet and run freely for one minute to ensure proper lubrication.


5.If pipeline refueller is not used, apply a small amount of spindle oil to the air inlet of the tool for every 8 hours of operation and then run freely for one minute to ensure proper lubrication.


6.Lubricate the drive screws. In some applications, it is recommended to immerse the first or two threads of the mandrel in light oil after multiple installations to minimize wear.


Please contact our engineers for the right solution.



麻将血流成河玩法 彩票怎么买,从没碰过 11选五中奖规则 山东11选5乐彩网 快乐10分中奖规则表 江西时时彩交易时间 白银市交易中心专家 上海快3开奖结果查询今天 天津时时彩是官彩吗 安徽快3今天开奖结果查询 山西快乐十分规则和奖金